Storage:
Keep in dry cool place. Exposure to excessive heat before use can result in flash setting.

Safety:
Always wear proper eye and respiratory protection.

Items Needed:
Drill, Clean Mixing Paddle, Clean 5 gal. Bucket, and Cold Water.

These instructions must be followed to ensure proper results.

1. Pour 13/4 gallons of cold water (warm water can result in flash setting) into a clean bucket.

2. Add approx. 3/4 of the contents of 1 bucket of dry Smoktite material to the water.

3. Mix immediately using a drill and clean mixing paddle.

4. Slowly add the remaining dry material and mix for approximately 3 minutes or until smooth.

5. Allow the mixed Smoktite to stand for 15 minutes while agitating approx. every 3 minutes.

6. Give the Smoktite a final thorough mix. The material should resemble thick pancake batter.

7. If needed -- adjustments can now be made by adding very small amounts of water to compensate for varying water chemistry, altitude, or weather conditions. These adjustments should be made just prior to use.

8. Smoktite material will remain usable, in a covered bucket, for an average of about 1 hour (under normal weather conditions) from the time of final mixing. However, additional mixing can be used to re-constitute the material. How ever, adding excess amounts of water can cause undesirable results.

NOTE: Always mix full buckets! Partial buckets risk having improper proportions of materials that may settle during shipping.